Melted wires going into the hotend | 3D Printing | Page 1

snow ridge Nov 2, 2023, 5:09 PM

#

I've got melted wires going into the hotend of my Anycubic Kobra Go. Is that normal or do I have a fire hazard on my hands?

split karmaBOT Nov 2, 2023, 5:09 PM

#

snow ridge I've got melted wires going into the hotend of my Anycubic Kobra Go. Is that nor...

#

AI Help

Melted wires going into the hotend of your 3D printer is definitely not normal and can pose a fire hazard. It's important to address this issue as soon as possible. You may want to check if the wires were properly secured and have not been damaged by excessive heat. It's recommended to discontinue using the printer until you can resolve this issue. If you're not comfortable troubleshooting it yourself, I advise you to reach out to Anycubic customer support or consult a professional for assistance.

snow ridge Nov 2, 2023, 5:09 PM

#

split karmaBOT Nov 2, 2023, 6:13 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

snow ridge Nov 2, 2023, 6:23 PM

#

.

#Melted wires going into the hotend