#Beep Sound

1 messages · Page 1 of 1 (latest)

soft marlin
#

Hello. I have Two Trees Bluer. During printing, a beep sound is played 3 times followed by a flat beep sound and it rises on the y-axis and resets itself. What is the reason?

flint prairieBOT
#
AI Help

The beeping sound followed by the printer resetting and moving on the y-axis could indicate a few possible issues with your Two Trees Bluer 3D printer. Here are a few troubleshooting steps you can try:

  1. Check your print bed: Ensure that the print bed is properly leveled and securely attached. Make sure it is not too close or far from the nozzle.
  2. Check the connections: Ensure all cables and connections between the printer and the control board are secure and properly plugged in.
  3. Update firmware: Check if there are any firmware updates available for your printer model. Updating the firmware might help resolve any software-related issues.
  4. Inspect the power supply: Verify that your printer is getting a stable power supply. If using a power adapter, make sure it is functioning correctly and providing the correct voltage.
  5. Test with a different file: Try printing a different file or model to see if the issue persists. It could be related to a specific file or model you are t...
WARNING: This response is AI generated and may contain errors.