#Nozzle drilling bed during homing after manual level

1 messages · Page 1 of 1 (latest)

orchid snow
#

I've got an ABL, I home all axis and then manual bed level with the screws, now when I re-home, it's smashing the nozzle into the bed?

dense windBOT
#
AI Help

It seems like the Z-axis height might not be properly calibrated. Try adjusting the Z-endstop switch or sensor to ensure that it triggers at the correct height before the nozzle touches the bed. Alternatively, you can adjust the bed leveling procedure to ensure that the nozzle is at an appropriate distance from the bed during homing. Remember to take caution and make gradual adjustments to avoid any damage.

WARNING: This response is AI generated and may contain errors.
orchid snow
#

I'm using the ABL as the endstop

#

the only solution i can think of right now is to just have the left side of the bed raised and let ABL fix it in the prints

#

or maybe I need to mount the ABL lower?

orchid snow
#

I think my problem is actually that the z-axis is bottoming out, I don't think it's the nozzle drilling the bed, I think it's the carriage not able to go down any further