E3v2 upgrades | 3D Printing | Page 1

lament ore Oct 25, 2023, 11:31 PM

#

Looking to upgrade my e3v2, already have bed springs, auto leveling, and dual gear extruder, what else should I get?

errant socketBOT Oct 25, 2023, 11:31 PM

#

#

AI Help

It sounds like you've already made some great upgrades to your printer! Here are a few additional upgrades you might consider:

Hotend upgrade: Consider upgrading to a high-quality hotend with good heat transfer and improved reliability.
Silent mainboard: Upgrading to a silent mainboard can significantly reduce the noise produced by your printer.
Filament runout sensor: A filament runout sensor can automatically pause your print when the filament runs out, preventing wasted time and failed prints.
Dual Z-axis: Adding a second Z-axis motor and lead screw can improve the stability and levelness of your printer's bed.

Remember to check compatibility and research these upgrades for your specific printer model before making a purchase.

errant socketBOT Oct 26, 2023, 12:34 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

fathom plaza Oct 26, 2023, 12:49 AM

#

PEI sheet

#

So much easier to remove prints

errant socketBOT Oct 26, 2023, 1:49 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

lament ore Oct 26, 2023, 1:57 AM

#

does a PEI sheet go on top of the glass build plate or directly on the metal bed?

fathom plaza Oct 26, 2023, 2:21 AM

#

Most sheets, like the one I have, come with a magnetic sheet that you stick to the metal bed and then place the sheet on top of that

#

Also if you decide to purchase a pei sheet, make sure you get one that's 235x235 and not 220x220, i made that mistake when I ordered my sheet

#E3v2 upgrades