#My filament won't come out

1 messages · Page 1 of 1 (latest)

wooden ridge
#

i have an ender 3 v2 and im trying to make butterfly knifes for my friends but i ran out of filament so im trying to use my other but the first filament won't come out

fat_lizard.jpg
rustic crowBOT
#
AI Help

If you're experiencing difficulties with filament not coming out of your Ender 3 V2, there could be several reasons for this issue. Here are a few steps you can follow to troubleshoot the problem:

  1. Check the filament path: Make sure there are no tangles or obstructions in the filament path, from the spool to the extruder. Sometimes filament can get stuck or tangled, preventing it from feeding properly.

  2. Verify the extruder tension: Ensure that the extruder tension is adjusted correctly. If it's too loose, the filament may not be gripping properly. If it's too tight, it can also cause issues with filament flow.

  3. Clear the nozzle: It's possible that a clogged nozzle is preventing filament from extruding. Heat up the nozzle to the printing temperature and use a small needle or unclogging tool to carefully clear any debris or filament buildup.

  4. Filament diameter and settings: Make sure you have selected the correct filament diameter in your slicing software and that the prin...

WARNING: This response is AI generated and may contain errors.
wooden ridge
#

am i meant to change filament like a glue gun...

rustic crowBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

thorny cliff
#

WDYK it won’t come out, but there should be a change filament option