Ender 3 v2 keeps clogging. | 3D Printing | Page 1

frozen briarBOT Oct 24, 2023, 4:09 AM

#

AI Help

It sounds like you've taken some great steps to improve your 3D printing setup. When you're experiencing issues with the first layer not adhering properly, there are a few things you can check:

Bed Leveling: Ensure that your printer's bed is properly leveled. A slight leveling adjustment might be needed if the nozzle is too close or too far from the bed.
Nozzle Height: Make sure the nozzle height is set correctly. It should be close enough to the bed to create a good squish, but not too close to prevent filament flow.
Bed Adhesion: Try using an adhesive for better bed adhesion. You can use painter's tape, glue stick, or a specialized 3D printing bed adhesive.
Extruder Calibration: Check if your extruder is calibrated properly. Under-extrusion can cause poor first layer adhesion. You may need to adjust the extrusion multiplier or flow rate in your slicer settings.
Temperature Settings: PLA generally prints well at temperatures between 195-220 degrees Celsius. You ...

nocturne holly Oct 24, 2023, 4:21 AM

#

Is the extruder motor overheating?

lone nest Oct 24, 2023, 4:23 AM

#

nocturne holly Is the extruder motor overheating?

how would i be able to tell?

nocturne holly Oct 24, 2023, 4:24 AM

#

Uncomfortable to touch?

lone nest Oct 24, 2023, 4:26 AM

#

i raged and turned it off let me turn it on again

#

actually i dont even wanna fuck with it. good night

nocturne holly Oct 24, 2023, 4:45 AM

#

Then i can’t really help that way

frozen briarBOT Oct 24, 2023, 5:49 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

digital sparrow Oct 25, 2023, 11:48 AM

#

lone nest actually i dont even wanna fuck with it. good night

Patience is key when dealing with 3D printers

#

Took me a month before my printer was fixed

#Ender 3 v2 keeps clogging.