#cr touch not correctly seting

1 messages · Page 1 of 1 (latest)

glossy harbor
#

I set up the cr touch correctly but then it jusdt gets a mind of its own and desides to scrape accross my bed i set the zstop correctly i think thats what i suspect it might be but i have been trying for 2 days and its stumping me. THX!

true fernBOT
#
AI Help

It sounds like you are experiencing difficulties with your CR Touch sensor. Here are a few troubleshooting steps you can try:

  1. Double-check your wiring connections: Ensure that the wires from the CR Touch sensor are properly connected to the designated pins on your 3D printer. Make sure there are no loose connections or wire damage.

  2. Verify firmware compatibility: Ensure that the firmware on your 3D printer is compatible with the CR Touch sensor. Check the manufacturer's documentation or website for the correct firmware version and update it if necessary.

  3. Calibrate the sensor: Follow the calibration process outlined in the CR Touch sensor's user manual. Pay attention to the recommended distance and speed during calibration. Make sure the probe is clean and free from any debris.

  4. Inspect your Z-stop switch: If you still suspect the Z-stop, carefully inspect it for any damage or misalignment. Make sure it's triggering correctly and not obstructed by anything.

  5. Software...

WARNING: This response is AI generated and may contain errors.
glossy harbor
#

ender 3 pro no mods merlin ver 1.1.2