#Whats wrong with my neptune 3 pro?

1 messages · Page 1 of 1 (latest)

clear whale
#

so i was having issies with my elegoo printer it was freezing, and popping up update firmware after hours of tinkering turns out one of the motors was unplugged it is a very loose connection.. Now i dont know whats going on the thing while printing at any moment is constantly starting and stopping even with previously good g code models. I was having great prints almost perfect now i cant even get a good first layer its got blobs where it starts and stringy lines. i looked it up and now i turned off resume printing option but to no avail. Now all my prints cant even get passed the first layer without looking messed up. I dont know what to do

rapid willowBOT
#
AI Help

It sounds like you are experiencing some issues with your Elegoo printer. Here are a few troubleshooting steps you can try:

  1. Check your printer's firmware: Make sure your printer firmware is up to date. Consult the manufacturer's website or support documentation for instructions on how to update the firmware.

  2. Check all connections: Double-check that all connections, especially the motor that was previously unplugged, are securely plugged in. Also, inspect the cables for any damages.

  3. Calibration: Ensure that your printer is properly calibrated. This includes leveling the bed and setting the correct nozzle height for the first layer.

  4. Filament issues: Check the quality of your filament. Sometimes using low-quality or improperly stored filament can cause printing issues. Try using a different spool of filament to see if the problem persists.

  5. Check slicer settings: Verify that your slicer settings are correct for your printer. Ensure that the correct filament diameter ...

WARNING: This response is AI generated and may contain errors.
rapid willowBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

clear whale
#

reset firmware within menu to see if that fixed things, tried a very small print and it seemed seemless. D: heart attacks im telling you lol