#Printer halted kill()

1 messages · Page 1 of 1 (latest)

near ridge
#

Hey! I modded my CR10 S5 to have the BTT SKR 1.4 Turbo with TMC2209 drivers.

It printed before and it all worked, but all of the sudden in one print I had a "SD Card released" error (the printer halted/disconnected afterwards) mid print.

Now I got this error message [image].
This happens righr before printing (I think right before hotend heating)

The printer printed successfully before that.

How can I debug the error? Googling it didn't suggest much and I worry that the motherboard might be unreliable, but I don't hope so.

20231019_194939.jpg 20231019_194944.jpg
raw hatchBOT
#
AI Help

Sorry to hear about the issue you're experiencing with your CR10 S5. The "SD Card released" error typically indicates a problem with the connectivity or communication between the printer and the SD card.

Here are a few troubleshooting steps you can try:

  1. Check the SD card: Ensure that the SD card is inserted correctly and securely into the printer's SD card slot. If possible, try a different SD card to see if the issue persists.

  2. Update firmware: Make sure your printer's firmware is up-to-date. Visit the manufacturer's website or the forum for your printer model to find the latest firmware version compatible with the BTT SKR 1.4 Turbo motherboard.

  3. Check the SD card slot: Inspect the SD card slot on the motherboard for any visible damage or debris. Clean it carefully with compressed air or a soft brush to remove any dust or dirt.

  4. Verify connections: Double-check all the connections between the BTT SKR 1.4 Turbo motherboard and other components. Ensure that all cables a...

WARNING: This response is AI generated and may contain errors.
near ridge
#

The SD card is inserted in the TFT and as I only had the SD error once and the kill() error multiple times it doesn't have to do with the TFT.

#

Ok now the SD card again.

#

Mid print, I could cry

#

It said somewhat along the lones of v90 or something and "Settings stored" and then SD card released again. But I was not able to catch the messages before quick enough

raw hatchBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

near ridge
#

Bump