#3D printer attempting to feed too much filament

1 messages · Page 1 of 1 (latest)

stable lichen
steel hedgeBOT
#
AI Help

To fix the issue of your 3D printer feeding too much filament, you can adjust some settings in Cura. Here are the steps you can follow:

  1. Download and open your Cura profile from the provided link.
  2. In Cura, click on the "Preferences" menu option and select "Configure Cura."
  3. In the configuration window, click on the "Printers" option.
  4. Select your printer from the list.
  5. In the settings, locate the section for "Extruder" and find the setting for the "Filament Diameter." Make sure this value matches the diameter of your filament.
  6. Next, locate the setting for "Extruder Steps per Unit" and adjust the value accordingly. Increasing this value will reduce the amount of filament being extruded, while decreasing it will increase the amount.
  7. Save your changes and close the configuration window.
  8. Load your 3D model into Cura, slice it, and try printing again.

By adjusting these settings, you should be able to control the amount of filament being fed to the nozzle and preve...

WARNING: This response is AI generated and may contain errors.
steel hedgeBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

frail hull
#

so, its trying to extrude, but cant melt fast enough?

steel hedgeBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

stable lichen
#

and eventuakly the bowden tube disconnects from the pressure

#

and nothing prints

livid egret
#

Print slower or get a higher flowrate hotend

stable lichen