#Ender 3 V2 Neo temperature fluctuations

1 messages · Page 1 of 1 (latest)

cyan solar
#

So thins is my 1st printer and ive been having temperature problems since about 2 and a half weeks ago. When i start a print at 200 and 60 on the bed, it starts moving fine but then when it gets close to the bed to print the temp drops to about 170 and nothing really comes out, and it just fluctuates from 180-210 after that until eventually it gives me the nozzle temperature is too low/high error and beeps loudly until i shut it off.

zinc sailBOT
#
AI Help

It sounds like you might be experiencing temperature fluctuations that are affecting your print quality. Here are a few troubleshooting steps you can try:

  1. Check your printer's cooling system: Make sure that the cooling fan(s) are functioning properly, as excessive heat can cause temperature fluctuations. Clean any dust or debris that may be blocking the airflow.

  2. Inspect the heating element: It's possible that the heating element in your printer's hot end may be malfunctioning. Check for any loose connections or signs of damage. If necessary, replace the heating element.

  3. Verify thermistor accuracy: The thermistor is responsible for measuring the nozzle temperature. Ensure that it is properly calibrated and securely attached to the hot end. If necessary, calibrate or replace the thermistor.

  4. Check the power supply: Insufficient power supply can cause temperature instability. Verify that your printer is getting a stable power supply and consider using a surge protector o...

WARNING: This response is AI generated and may contain errors.
zinc sailBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

wraith wigeon