#Ender 3 V2 Neo Prints stuck to bed

1 messages · Page 1 of 1 (latest)

abstract tangle
#

I'm unable to remove a print with it's brim from the bed once it's done. I got the print off but the brim is still stuck to the bed. I have the magnetic flexible bed with that sanded finish. I've tried taking it off after flexing the bed, tried a scraper but I can't get the brim off. Any suggestions on how I can take it off?

unreal mapleBOT
#
AI Help

If the brim is still stuck to the bed after using a scraper and flexing the bed, you can try a few different methods to remove it:

  1. Heat the bed: If your printer has a heated bed, try heating it up to the temperature at which you printed the brim. The heat may help soften the brim, making it easier to remove. Be careful not to overheat the bed or use excessive force when removing the brim.

  2. Use isopropyl alcohol: Soak a cloth or paper towel with isopropyl alcohol and apply it to the brim. Let it sit for a few minutes to weaken the adhesive properties of the brim. Then, gently scrape it off with a scraper tool.

  3. Apply a glue stick: If the brim is not coming off easily, you can try applying a glue stick directly onto the brim. Allow it to dry and then try removing the brim again. The glue stick can provide an extra layer between the brim and the bed, making it easier to separate them.

Remember to be gentle when attempting to remove the brim to avoid damaging the bed surface....

WARNING: This response is AI generated and may contain errors.
full karma
#

Have you tried heating your bed to 80° or so and then taking a scraper to it?

abstract tangle
#

I tried heating it to 60, taking the bed off and then scraping it. I'll try it again while the bed is heating it. Is it safe to heat it till 80 though?

full karma
#

Yeah

#

I used to do that with PETG prints when I had a glass bed and they came off pretty well

abstract tangle
#

Got it, I'll try heating it and taking it off. Currently I'm trying the IPA method suggested by the bot, will try it in a few minutes

full karma
#

Heat it to 80 or so, let it sit for a few minutes so that the filament can absorb the heat, leave the bed on the printer and take a scraper to it

abstract tangle
#

Ok, will try it out now

neat fiber
#

Did it work

abstract tangle
#

Yup, it worked. I started peeling it off by hand at 80

#

@full karma Thanks a lot!!!

unreal mapleBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

full karma