#Ender3V2Neo Stops mid print

1 messages · Page 1 of 1 (latest)

static swan
#

Hi, so I have been having some trouble while printing PETG with 0.6mm nozzle on Ender3 V2 Neo, so I have printed some things with PETG with 0.4mm nozzle(Original Creality One) at 240 degrees and they were really good and everything went smooth, now I tried doing it with 0.6mm nozzle(its from ebay) and just like few layers into the print or like half print it just beeps lound and says hotend and bed temp low, and just stops mid print, I'm using 0.6mm nozzle with PLA at 205 degrees and works perfectly, but with PETG at 240 degrees it just does that thing, and I saw that like nozzle goes from brass color to kinda rainbow one I didnt notice it before, does anybody have any tips or answers to my problem. Thanks (I'm using mriscoc firmware), EDIT: I used stock tube not the ptfe one

slow treeBOT
#
AI Help

It seems like you are experiencing some issues while printing PETG with a 0.6mm nozzle on your Ender3 V2 Neo. Here are a few suggestions to troubleshoot the problem:

  1. Ensure that your hotend is properly calibrated and the temperature readings are accurate. You can use a separate thermometer to verify if the temperatures displayed on your printer are correct. If not, you may need to recalibrate or replace the temperature sensor.

  2. Check the electrical connections, especially the wiring for your hotend and heated bed. Loose or faulty connections can cause temperature fluctuations, leading to the error you mentioned. Make sure all wires are securely connected and inspect for any signs of damage.

  3. Consider adjusting the printing temperature for your PETG filament. While 240 degrees Celsius is a common starting point, different brands or batches of filament may require slightly higher or lower temperatures to print optimally. Experiment with gradually increasing or decreasing the...

WARNING: This response is AI generated and may contain errors.