#Having problems starting a print

1 messages · Page 1 of 1 (latest)

somber flaxBOT
#
AI Help

It sounds like a mechanical issue with your printer. The weird noise could indicate that something is grinding or rubbing against each other during the bed leveling process. Here are a few troubleshooting steps you can try:

  1. Check for any visible obstructions or loose parts around the printer's x and y-axis, especially near the bed leveling mechanism.

  2. Ensure that the CRtouch sensor is properly installed and securely attached to the printer. Double-check the wiring connections as well.

  3. Make sure the printer's firmware and software are up to date. Sometimes, updating the firmware can fix compatibility issues that cause strange noises.

  4. Check if there are any loose belts or pulleys in your printer's mechanics. Tighten them if needed.

If the issue persists after these steps, it might be best to contact the manufacturer's technical support or seek help from the printer's online community for further assistance.

WARNING: This response is AI generated and may contain errors.
quick sandal
#

Is it ramming the bed? Almost looks like it

stoic bolt
#

lemme send a video of what happens after it does that

#

seems like it started working

#

guess it fixed it self

quick sandal
stoic bolt