#Settings for supports

1 messages · Page 1 of 1 (latest)

heady fable
#

Every time I print something with supports they either won’t come off or they come of the the print is all scratched up does anyone know what settings or what I need to do to stop that?

I have a Ender 3 and Ender 3V2, no mods just a glass build plate. I use the creality slicer 4.8

silk mossBOT
#
AI Help

When dealing with supports sticking or leaving scratches on your prints, there are a few things you can try to improve the situation:

  1. Adjust support settings in your slicer: In Creality Slicer 4.8, go to the support settings and decrease the support density or use a different support pattern like grid or lines. Additionally, make sure the support interface layers are enabled to create a smoother surface where the support attaches to your model.

  2. Reduce support adhesion: Sometimes supports stick too well to the printed object and become difficult to remove. You can try adjusting the support z-gap in your slicing software to increase the gap between your print and the supports. This will make it easier to remove them without damaging the print.

  3. Improve print bed leveling: Ensure your print bed is properly leveled. A well-leveled bed will result in better adhesion and easier removal of supports. Use a piece of paper or feeler gauge to ensure the nozzle height is consistent a...

WARNING: This response is AI generated and may contain errors.
silk mossBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

heady fable
#

So I changed the settings and I was able to get the support off but it’s still scratched up

silk mossBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

heady fable
#

How can I fix this?