#new prinnter keeps shutting off

1 messages · Page 1 of 1 (latest)

low bobcat
#

I just recieved a new Ender 3 V3 SE today, set it up following the directions, i try to calibrate or start a print and it just, shuts resets. I have no idea what is going on but i see stuff about having too big of a psu? Cant find anything more about that. Checked the firmware. Checked all the connections, not sure whats wrong

cerulean orioleBOT
#
AI Help

It sounds like you are experiencing some issues with your Ender 3 V3 SE. Random resets during calibration or printing can be caused by various factors. However, the power supply unit (PSU) is unlikely to be the issue in this case, as the Ender 3 V3 SE comes with an appropriate PSU for its specifications.

Here are a few troubleshooting steps you can try:

  1. Make sure all the connections are secure: Ensure that all cables and connectors are properly connected and seated. This includes the power cable, USB cable, and all connections to the mainboard.

  2. Check the mainboard and firmware: Ensure that you have the latest firmware installed on your Ender 3 V3 SE. You can refer to the manufacturer's website for instructions on how to update the firmware correctly.

  3. Test the power capacity of the outlet: Ensure that you are using a stable power source. Try plugging the printer into a different outlet or using a surge protector to rule out any electrical issues.

  4. Review the G-code an...

WARNING: This response is AI generated and may contain errors.
cerulean orioleBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

low bobcat
#

i found the voltage switch, glad that this stuff is in the manual...

#

!solved

#

?solved