#Kobra-Go mechanical issue.

1 messages · Page 1 of 1 (latest)

mossy epoch
#

Ok so, my Anycubic Kobra-go has an issue with the Y axis, it seems to be a mechanical issue on the track. I do not believe it is the wheels, because it only get stuck at one spot. So it is must be the track or the belt.

How would you go about figuring out what specifically is wrong, and fixing it?

finite craneBOT
#
AI Help

To figure out the specific issue with the Y axis on your Anycubic Kobra-go, you can follow these steps:

  1. Check the belt tension: Ensure that the Y-axis belt is properly tensioned. If it is loose, tighten the belt using the tensioning mechanism provided by the printer's design.

  2. Inspect the track: Carefully examine the track where the Y-axis moves and look for any obstructions, debris, or damage. Clean the track if needed, and remove any debris that may be causing the issue.

  3. Lubricate the track: If the track appears clean, lubricate it with a suitable lubricant like a light machine oil or lithium grease. Apply a small amount along the track to ensure smooth movement of the Y-axis.

  4. Check the wheels: While you mentioned it's unlikely to be an issue with the wheels, it's still worth checking. Inspect the wheels for any damage or wear. Ensure they are properly aligned and tightened. If necessary, replace the wheels with new ones.

  5. Test the Y-axis movement: After performi...

WARNING: This response is AI generated and may contain errors.