first problems | 3D Printing | Page 1

vague gorge Sep 28, 2023, 10:12 PM

#

so couple of things, at the end of the print, the bed kind of rammed into the frame and the motors kep spinning for a sec, is that normal. and i just finished the benchy but when i tried to pull of the print the bottom layer kinda ripped of with it, is there a way to fix that or is that normal.
i heard that the first one is just limits not set correctly and i guess that would be in the manual on how to fix it. and for the second one i dont really know if its a problem

onyx helmBOT Sep 28, 2023, 10:12 PM

#

vague gorge so couple of things, at the end of the print, the bed kind of rammed into the fr...

#

AI Help

Regarding the first issue, if the bed is ramming into the frame and the motors are still spinning, it is not normal. This might indicate that the endstop or limit switch for the bed is not properly configured. Check your printer's manual for instructions on how to set the correct bed limits.

For the second issue, it's common for the bottom layer to be difficult to remove and sometimes tear off with the print. You can try using a spatula or scraper to carefully detach the print from the bed. Applying a thin layer of glue stick or using a heated bed can also help with adhesion and make it easier to remove the print without damaging the bottom layer.

latent belfry Sep 28, 2023, 10:13 PM

#

Could you send a pic of the benchy?

vague gorge Sep 28, 2023, 10:14 PM

#

On the left u can see the bottom layer on the top side removed and I’m wondering if that’s normal or if I should change smth

pulsar gorge Sep 28, 2023, 10:18 PM

#

Lower your z_offset

latent belfry Sep 28, 2023, 10:22 PM

#

vague gorge On the left u can see the bottom layer on the top side removed and I’m wondering...

Looks like your nozzle was too far away from the bed, you have to lower Z offset just like Full Moon said

onyx helmBOT Sep 28, 2023, 11:22 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

vague gorge Sep 29, 2023, 6:17 AM

#

latent belfry Looks like your nozzle was too far away from the bed, you have to lower Z offset...

With what increments would that be? I thought I already had it pretty close

onyx helmBOT Sep 29, 2023, 7:17 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

latent belfry Sep 29, 2023, 7:48 AM

#

vague gorge With what increments would that be? I thought I already had it pretty close

Maybe 0.05mm closer and check again, I'd expect this one to be slightly too close

#first problems