#Cura last layer on layer 10

1 messages · Page 1 of 1 (latest)

small atlas
#

When i sliced this model, at layer 10 it shows the whole model already printed plus some random lines from one corner to the model, but then on layer 11 goes back to normal as it should be. It happens when the printer finish the support, then goes to last layer, then goes to first layer and starts as normal, if i dont use supports it slice correctly

27586ced323c6fc739546847b15a7b94.png
past ospreyBOT
#
AI Help

It sounds like you may be experiencing a slicing issue with your model. This could be caused by various factors such as incorrect settings, corrupted model files, or issues with the slicing software itself. Here are a few steps you can take to troubleshoot this problem:

  1. Verify model integrity: Check if there are any errors or issues with the 3D model file itself. You can try opening it in a different software or repairing it using model repair tools.

  2. Check slicing settings: Review your slicing software settings, specifically the layer height, infill, and shell settings. Make sure they are appropriate for your printer and model.

  3. Update slicing software: Ensure that you're using the latest version of the slicing software you're using. Bugs or issues may have been addressed in newer releases.

  4. Reduce printer speed: Try slowing down the printing speed as it might be causing the random lines. This could be a possible temporary solution.

  5. Seek community support: Reach ou...

WARNING: This response is AI generated and may contain errors.