My extruder works during a purge line but fails to spin now when actually printing. Whats going on?

[raw shard]

Was printing perfectly fine before it starting skipping and extruder wheel not spinning during print, but it spins freely when i spin it during a print which means the motor isnt enguaging....but it does on the purge line.....im so confused

[brittle siren]

AI Help

It sounds like you may be experiencing a technical issue with your 3D printer's extruder motor. Here are a few troubleshooting steps you can try to resolve the problem:

1. Check the wiring: Ensure that all connections between the extruder motor and the control board are secure and properly connected.

2. Review firmware settings: Verify that the correct motor settings, such as the steps per millimeter and motor current, are configured in your printer's firmware.

3. Check motor driver: If you are using a stepper motor, ensure that the motor driver module is functioning correctly. You may need to adjust the motor driver voltage or replace it if necessary.

4. Examine the filament path: Check for any obstructions or tangles that may be preventing the filament from feeding properly. Make sure the filament is not tangled or stuck in the extruder assembly.

5. Test the motor: Disconnect the extruder motor from the printer and test it separately. You can use different motor control softw...

WARNING: This response is AI generated and may contain errors.