#z axis keeps going off after I bed leveled it

1 messages · Page 1 of 1 (latest)

balmy questBOT
#
AI Help

It seems like you're facing some issues with your 3D printer. Based on your description, it sounds like your z-axis is not properly calibrated or there could be an issue with the leveling of your print bed. Here are a few troubleshooting steps you can try:

  1. Double-check your bed leveling: Make sure that your print bed is properly leveled. Use a sheet of paper or a feeler gauge to ensure that the nozzle is at the correct distance from the bed at all corners.

  2. Check your z-axis calibration: Ensure that the z-axis is properly calibrated and moves smoothly. Check if the z-axis stepper motor is secure and not loose. You might need to refer to your printer's manual or online resources for specific instructions on how to calibrate the z-axis.

  3. Check for any mechanical issues: Inspect the printer for any loose belts, misaligned rods, or any other mechanical issues that could cause the z-axis to behave erratically.

  4. Update firmware: Although you mentioned that you already install...

WARNING: This response is AI generated and may contain errors.
graceful onyx
#

can anybody help me with this?
hey guys i got sort in a problem... I had bed leveled it and before this was recorded and when I bed leveled it and started the print it just hops and goes off and when I stop it the z axis is like close to the bed. *I had installed the latest marlin firmware before this video and sorry for the blurred video.

#

would be a appreciated help if anybody fixes this weird problem i had going for 9 months

formal rock
#

when set hit the save settings button at the bottom of the menu

graceful onyx
#

ok

graceful onyx
formal rock
#

bottom of settings

graceful onyx
graceful onyx
graceful onyx
formal rock
#

store settings sorry

graceful onyx
#

ok

#

nope

graceful onyx
formal rock
#

Hum

#

Interesting sorry

#

Idk

#

It’s probably the firmware