IS-3 TANK 1:50

[crude leaf]

I printed it and painted!

[oblique surge]

thats amazing, one of my fav tanks

is the stl public?

[crude leaf]

I could give it to you

[crude leaf]

But I found in thingiverse I guess

[oblique surge]

would appreciate it!

[crude leaf]

But little later 😅
Cuz school

[oblique surge]

sure no problem

[limpid stratus]

whaaaat. Thats crazy good for an FDM model. hows the undersinde of the hull?

[crude leaf]

Good I guess

[keen pendant]

noice is3

[crude leaf]

Thanks

[keen pendant]

assuming he used the same designer i used, its pretty much just flat

[limpid stratus]

which is fine when it comes to resin printers, but having ugly supports sounds like not fun to me

[crude leaf]

I printed this Is-3 on Anycubic mega S 3d printer

[keen pendant]

yea when i printed my tanks, each one came with a bunch of support under the hull, which in most cases, is simple eough to clear out in 1 piece (satisfying) but sometimes it doesnt and comes off in like 10 pieces

[crude leaf]

When I started with printing tanks, one my poor fingers
Covered in blood after clearing

[keen pendant]

rip fingy