3d Printing problem Ender 3 Neo

[delicate crow]

Hello! how are you?
I make this thread so maybe you can help me. I have a problem with my 3d printings in the Ender 3 Neo.
I also have a Cr-10s pro v2 and works perfect, but when I try to print the same thing on my Neo printer it doesn't go well.
It's well calibrated but the problem is with the fill and walls. It have some lines or spikes, like waves, also the filler doesn't do the lines.
Here I leave some pictures. I use Prusa Slicer with this settings (picture):

Thank you!

[sturdy pulsar]

AI Help

Hello! I'm doing well, thank you for asking. I'll be happy to help you with your 3D printing issue.

Based on the pictures you provided, it seems like you might be experiencing an issue with layer adhesion or extrusion. Here are a few troubleshooting steps you can try:

1. Check the filament: Make sure your filament is not tangled or damaged. It's also worth double-checking if you're using the correct filament diameter for your printer.

2. Check the extruder: Ensure that the extruder gear is clean and properly gripping the filament. Also, make sure the tension on the filament is not too tight or too loose.

3. Calibration: Even though you mentioned that your printer is well calibrated, it's worth rechecking the bed leveling and nozzle height to ensure they are properly set. Improper calibration can cause issues with layer adhesion and quality.

4. Print temperature: Experiment with adjusting the print temperature slightly to see if it improves the print quality. Higher temperatures...

WARNING: This response is AI generated and may contain errors.