After Firmware Update Bambu P1P top layer super rough

[blissful light]

After updating my P1P to the latest firmware my top layers have been coming out super rough. If I run the calibration tool it seems to go away for one print then comes straight back. I am running all settings default in the bambu slicer. Has anyone else had a similiar issue?

[leaden verge]

AI Help

It's possible that the latest firmware update might have introduced some changes that are causing the rough top layers. One potential solution could be to reset the printer settings to default and reconfigure them manually. Additionally, make sure that your bed leveling is properly calibrated and check if there are any issues with the slicer settings. It can also be helpful to reach out to the manufacturer or check online forums for other users who might have experienced similar issues and find out if there are any known solutions or workarounds.

WARNING: This response is AI generated and may contain errors.

[blissful light]

Bambu P1P

Bambu Slicer

I hope these images help

I am using Hatchbox black PLA

[leaden verge]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[blissful light]

Bump

[leaden verge]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[blissful light]

bump

After Firmware Update Bambu P1P top layer super rough

[leaden verge]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[blissful light]

bump