#artillery genius pro bed adhesion

1 messages · Page 1 of 1 (latest)

young pond
#

Hi.
I have a question about the print surface from my artillery genius pro 3d printer. Whenever I print objects with flat surfaces the models stick to the print surface just fine. But as soon as there are some elements in the first layer so that it isn't one continous layer (like circles or rectangles --> picture, the rectangle is a bit messed up) it struggles printing them. They never stick. What to do?

IMG20230902192334.jpg
worthy creekBOT
#
AI Help

Hello! It sounds like you're experiencing some adhesion issues with your Artillery Genius Pro 3D printer. Here are a few troubleshooting steps you can try:

  1. Leveling the print bed: Make sure your print bed is properly leveled. This ensures that the nozzle is at the correct height and allows for proper adhesion. Follow the printer's instructions for bed leveling.

  2. Clean the print surface: Ensure that the print surface is clean and free from any debris or residue. You can use isopropyl alcohol or a mild dish detergent and water solution to clean it thoroughly.

  3. Adjust the first layer height: If your first layer is not sticking well, try adjusting the Z-axis height slightly closer to the bed. You can usually adjust this setting in your printer's firmware or slicer software.

  4. Use a good adhesive: Applying a thin layer of adhesion aid like hairspray, glue stick, or specialized 3D printing bed adhesives can help improve bed adhesion. Experiment with different methods to see wh...

WARNING: This response is AI generated and may contain errors.