#Frankenstein Firmwear

1 messages · Page 1 of 1 (latest)

terse cipher
#

hey can anyone help with my firmwear? I have a original ender 3, with an upgraded "sprite extruder pro upgrade kit", a CR touch, i removed the z axis switch, 2.2.7v upgraded silent board, double z axis lead screw upgrade, and other things that wont effect the firmwear like lights and an enclosure. I am going crazy trying to make a firmwear work. the closest i got to was using a 2.2.7v Cr touch creality merlin premade firmwear BUT the probe XYZ distance was wrong since it thinks it's on an original ender 3 head. so i used a GCODE file to change it to the specified one in the hotends manual. it makes the probe miss the bed (less then it did before which was an improvement a little changing the offset) but the nozzle tries to push into the bed (itll keep going until the probe is hit but it never will be considering its over hanging). anyone know what i may have to do? are there any settings other then basic retracting and max temp settings i have to change that would effect the bed leveling? I have been trying to do this for about a week an cant figure it out so was hoping someone would maybe know. Thanks!

full cypressBOT
#
AI Help

I'd be happy to help you with your firmware issue! It sounds like you've made a lot of modifications to your Ender 3. When updating firmware for a printer with multiple modifications, it can sometimes be a little complicated to get everything working properly. Here are a few suggestions to troubleshoot the issue you described:

  1. Calibration: Double-check that your CR touch is properly calibrated and the offsets are accurately set. It's crucial for successful bed leveling.
  2. Firmware Configuration: Make sure you are using the correct firmware configuration for your specific printer setup. It's possible that the pre-made firmware you tried doesn't have the correct settings for your modified Ender 3.
  3. Probe offset: If your probe is not correctly aligned with the nozzle, it can cause issues. Ensure that the probe offset values in the firmware match the physical distance between the probe and the nozzle.
  4. Probe sensitivity: Check the probe sensitivity settings in your firmware. Ad...
WARNING: This response is AI generated and may contain errors.
full cypressBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

north shale
#

Sounds like you need to do a proper firmware update, those are all updates that need a merlin update