#Problems with Ender 3 Neo

1 messages · Page 1 of 1 (latest)

wind sable
#

Hello, I recently purchased an Ender 3 Neo and I’ve had some issues with it not printing correctly, and extruding filament when it is not printing anything. I will attach some files below showing this. Also, I have had issues with stringing, and supports. I have attached a video of two prints and how they turned out. (White is PETG, gold is PLA).

Any help or tips on how to fix these issues would be much appreciated, thanks.

IMG_3210.jpg
scenic tulipBOT
#
AI Help

Hello! I'll be glad to help you with the issues you're experiencing with your Ender 3 Neo. Unfortunately, I'm unable to view any attached files or videos. However, based on the description you provided, here are some suggestions to troubleshoot your problems:

  1. Filament extruding when not printing: This is most likely caused by incorrect slicing settings or a clogged nozzle. Check your G-code settings to ensure that the printer is not retracting too far after a print. Clean or replace the nozzle if it's clogged.

  2. Stringing: Stringing occurs when the printer leaves traces of filament between different parts of the print. To reduce stringing, try increasing the retraction distance and speed in your slicer settings. You can also lower the print temperature slightly or enable features like "coasting" or "wipe" in your slicer.

  3. Supports: If you're having issues with supports not printing or not providing enough support, try adjusting your support settings in the slicer. Increase ...

WARNING: This response is AI generated and may contain errors.
scenic tulipBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

sour palm
#

Looks like you’re to close to your bed.

weak gazelle
#

Z level and filament flow