#Auto leveling failed on anycubic kobra go

1 messages · Page 1 of 1 (latest)

jagged gust
#

I am unable to level my printer, when i try it says 'Auto leveling failed' I have tried reflashing the firmware and i am unsure what to do

slim portalBOT
#
AI Help

If you are experiencing difficulty leveling your 3D printer and have already tried reflashing the firmware, here are a few troubleshooting steps you can try:

  1. Make sure the printer's bed is clean and free from any debris that might affect the leveling process.
  2. Ensure that the printer's nozzle is clean and not clogged, as this can prevent proper leveling.
  3. Double-check that the printer's sensors or probe are functioning correctly. If they are dirty or damaged, they may not be able to perform accurate leveling.
  4. Check if the printer's bed is properly secured and not loose, as this can affect the accuracy of the leveling process.
  5. Verify that the printer's firmware is compatible with the leveling system being used. If not, try installing a firmware version that supports auto-leveling.

If the problem persists after trying these steps, consult your printer's user manual or contact the manufacturer's technical support for further assistance.

WARNING: This response is AI generated and may contain errors.
jagged gust
#

It is a anycubic kobra go, running firmware v1.3.4 and have attempted to adjust the height of the proximity sensor