#Ender 3 cant set extrusion rate.

1 messages · Page 1 of 1 (latest)

runic hornet
#

i have an Ender 3, with a creality touch screen (without knob) and it does not have E-step adjustment settings built in. Ive already set the extrusion multiplier value to max via g-code, but my benchys are still coming out crunchy and tear apart horizontally quite easily, although they hold their shape.

boreal condorBOT
#
AI Help

It's possible that the issues with your prints are not related to the extrusion steps or the extrusion multiplier value. Here are a few troubleshooting steps you can try:

  1. Check the filament diameter: Make sure the filament diameter you have set in your slicer matches the actual diameter of your filament. Using a caliper, measure the filament at multiple points and adjust the value in your slicer accordingly.

  2. Check the extruder gear tension: Ensure that the tension on the extruder gear is properly adjusted. If it's too tight or too loose, it can affect the extrusion consistency. Consult your printer's manual for instructions on adjusting the tension properly.

  3. Calibrate the extruder steps/mm: Although your printer might not have a built-in feature for adjusting E-steps, you can still calibrate it manually. There are helpful tutorials available online that can guide you through the process. This will ensure that the correct amount of filament is being extruded.

  4. Verify t...

WARNING: This response is AI generated and may contain errors.