vast creek
I've had my printer (Ender 3 V1 Pro) for about a year now, and I've gotten a mix of print results. Some prints have worked perfectly fine, while others refuse to print, seemingly impossible to print. I just switched over from Cura's slicer to Creality with a friend's recommendation, and I haven't really noticed a difference while printing large prints. I've also noticed a number of errors come from large prints, while small prints seem to do ok at times. I've already leveled the bed, cleaned it, checked all measurements and numbers. I'm using the recommended heat (PLA) and its still spotty. I've seen a number of different issues including adhesion issues, leading to strings off filament being dragged across the bed, ruining the print. In the photo posted, I'm trying to print an M113 but end up with a mess, just for the thin layer to get stuck to the bed. It sticks but it doesn't???? It would make more sense if every print failed, but I just printed a knight piece for DND, and it turned out perfect. I've tried everything and have gotten no where. Please Help.
stray talon