#These horrible gashes keep appearing on my prints and I have no idea why!

1 messages · Page 1 of 1 (latest)

desert turret
#

I thought it was a linear advance/pressure advance thing but I ended no fully tuning it and this happens anyway. Is my speed too high?
This print defect will be showing up in my nightmares

20230810_234136.jpg 20230810_234132.jpg
mild ospreyBOT
#
AI Help

It's possible that the speed setting is causing the issue, but there are also other factors that could contribute to print defects. To determine whether the speed is the problem, you can try reducing the speed and see if the issue improves. Additionally, check if the nozzle is clean, the filament is of good quality, and the extruder tension is properly adjusted. It may also be helpful to provide more specific details or images of the print defect for a more accurate assessment.

WARNING: This response is AI generated and may contain errors.
stark tundra
#

What print speed?

desert turret
#

130mm/s

#

using the whole flow I am getting (16 mm^3/s)

mild ospreyBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.