#Hi I need help getting rid of these artefacts

1 messages · Page 1 of 1 (latest)

storm zenith
#

Hello as said in the titles I have something going on I don't know how to get rid of

This happens at the slowers layers of the print

Printed on x1c with pla and default settings with 5% gyroid

Thank you for any help

IMG_20230810_095538.jpg IMG_20230810_095514.jpg IMG_20230810_125124.jpg
grave topazBOT
#
AI Help

It sounds like you're experiencing an issue with your 3D print at the slower layers. There could be a few potential causes for this problem. Here are a few troubleshooting steps you can try:

  1. Check your print bed leveling: Ensure that your print bed is properly leveled. An uneven print bed can lead to issues with adhesion and cause problems in the lower layers of the print.

  2. Adjust the print speed: Try reducing the print speed for the slower layers. Slowing down the print speed can help with precision and reduce the chances of any issues occurring.

  3. Check filament quality: Make sure that your PLA filament is of good quality and not brittle or moisture-absorbed. Poor-quality filament can cause problems during printing, especially with layer adhesion.

  4. Increase layer adhesion: You can try adjusting the first layer settings in your slicer software to ensure better adhesion between the print and the bed.

  5. Increase nozzle temperature: Sometimes, increasing the nozzle tempe...

WARNING: This response is AI generated and may contain errors.
grave topazBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

storm zenith
#

Up

grave topazBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

storm zenith
#

Up

grave topazBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

storm zenith
#

Uup

#

Il Desperate pls pls help

restive nymph
#

Are you referring to the lines going around the print?

storm zenith
#

Yes this one here

restive nymph
#

Is that at the top of the inside layer?

storm zenith
#

Yes it's a top surface
The problem occurs at the three yellow layers in the slicer picture

#

Every other layer is pink

restive nymph
#

Yeah definitely related to it printing it differently at those layers. There might be some things you can tweak in terms of the order it prints walls and infill, or how many walls are printed. Why is it a problem? Cosmetic?

storm zenith
#

Yes it's supposed to be a lithobox but these lines are clearly affecting the aesthetic

I will try inverting wall order that s a good idea thx !

But if you know of a way to tweak the gcode at those layers idk maybe lowering the speed or something ..?

grave topazBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

storm zenith
#

Up

grave topazBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

restive nymph
#

Unsure, it's pretty minor and might just be in the range of quirks of how your printer prints, but I'm not an expert.