printer middle bar not align

[zealous bramble]

Hey, I'm new here. Pretty much some prints I did have some problems so I was messing with leveling my bed then realized that my middle bar I can move easily up and down so it looks tilted. It's prob. A noob mistake anything helps. That line in the 3d print is not supposed to be there and it happened on 2 of that same print.

[verbal iron]

AI Help

It sounds like your printer's X-axis gantry might not be leveled properly. To fix this, you'll need to adjust the tension on the eccentric nuts that hold the gantry in place.

First, locate the eccentric nuts on both sides of the gantry where it connects to the frame. Tighten the nut on the side where the gantry is too loose, and loosen the nut on the opposite side. This will help align the gantry and make it level.

You can check the levelness of the gantry by using a straight edge or a level. Place it along the horizontal rails of the gantry and see if it sits flat and level. Adjust the eccentric nuts until the gantry is level.

After you've made these adjustments, re-level your print bed and try another print. Hopefully, the tilted line issue will be resolved. Let me know if you have any further questions or need more assistance!

WARNING: This response is AI generated and may contain errors.

[zealous bramble]

Ender 3 pro, I do have a quistion I can't find the electronic nuts where are they?

@verbal iron Ender 3 pro, I do have a quistion I can't find the electronic nuts where are they?

I found I yt video I want to try if you have anything that will help feel free to comment I will be trying it another day because the tools are at a different location