#Gaps/stringing(?) in-between layers

1 messages · Page 1 of 1 (latest)

half elk
#

Hello! After doing a print recently of a webcam cover and while watching it print, I noticed what appeared to be stringing and/or gaps in-between some of the layers? I’m honestly not sure what could be causing this issue, but I wanted to see if anyone else might know. Thanks.

IMG_2675.jpg IMG_2676.jpg
mighty sluiceBOT
#
AI Help

Hello! It sounds like you might be experiencing issues with stringing and/or gaps in your print. This can be caused by a few different factors:

  1. Incorrect retraction settings: Stringing can occur when your printer doesn't retract the filament properly between moves. Check your printer settings and make sure that the retraction distance and speed are appropriately configured.

  2. Filament temperature: If the filament is too hot, it can be more prone to stringing. Try lowering the temperature slightly and see if it helps.

  3. Print speed: Printing too quickly can also contribute to stringing. Slow down the print speed and see if it improves the problem.

  4. Z-axis alignment: If there are gaps between layers, it could be due to incorrect Z-axis calibration. Check that your printer's bed is properly leveled and calibrated.

  5. Filament quality: Poor quality or old filament can also lead to stringing and gaps. Make sure you're using fresh, high-quality filament.

I hope these suggesti...

WARNING: This response is AI generated and may contain errors.
half elk
#

The printer I'm using for reference is an Ender 3 Pro that I recently swapped the stock extruder out on for an all metal one. I did go about calibrating the E steps following that.

#

I also have a BL Touch fitted to the printer to compensate for any variations after doing my best to level the bed.