#why is my prints doing the with out side and inside layers seperating

1 messages · Page 1 of 1 (latest)

coral marsh
#

ender 3 pla 200 c and 5o c print temps out side layers and inside layer not sticking why?😫

IMG_20230716_095405.jpg
worthy chasmBOT
#
AI Help

There could be a few reasons why your outside layers and inside layers are not sticking properly at the recommended temperature settings. Here are a few troubleshooting steps you can try:

  1. Check your bed leveling: Make sure your printer's bed is properly leveled. If it is not leveled, it can lead to inconsistent adhesion.

  2. Clean the print surface: Ensure that the print bed is clean and free from any residue or oil. Sometimes, a dirty print surface can prevent layers from sticking.

  3. Adjust the nozzle height: If the nozzle is too far away from the bed, it may result in poor layer adhesion. Try adjusting the nozzle height slightly closer to the bed to improve adhesion.

  4. Increase bed temperature: PLA can benefit from a slightly higher bed temperature. Try increasing the bed temperature by a few degrees (e.g., from 50°C to 60°C) to see if it improves layer adhesion.

  5. Slow down print speed: Printing too fast can also affect layer adhesion. Try reducing the print speed to gi...

WARNING: This response is AI generated and may contain errors.
coral marsh
#

all this has been checked and triple checked

green ingot
#

what is your linewidth set to?

obsidian pollen
#

Have you tried higher nozzle temps? All kinds of factors can affect the ideal temperature, it's the first thing I adjust when I'm having problems with layer adhesion.