#XZ offest probig

1 messages · Page 1 of 1 (latest)

gaunt radishBOT
#
AI Help

If your Sovol SV06 fails the test you described, there are a few potential issues you can check to troubleshoot the problem:

  1. Make sure your printer is properly homing: The "G28" command should correctly home the printer, ensuring that all axes are properly aligned and at their respective endstops.

  2. Check the Z-axis height: The "G0 Z20" command should move the nozzle 20mm away from the bed. Verify that the distance is correct, as too low or too high of a value can affect the accuracy of subsequent commands.

  3. Confirm X and Y-axis movement: The "G0 X30 Y30" command should move the nozzle to the specified position (X=30, Y=30). Ensure that X and Y axes are moving properly and reaching the correct positions.

  4. Verify the marking and probing: The step involving marking and probing the point (G30 X30 Y30) is crucial. Ensure that you accurately marked the spot below the nozzle, and the printer should move the probe to that point.

If your printer is not performing as expected, i...

WARNING: This response is AI generated and may contain errors.
west raptor
#

can you send video of this

#

it could be a wire in the way the sensors

gritty meadow
#

wait i will send you what a moderator from marlin told me to do

#

i dont understand what he means

#

i will send a video

#

in 1 minute

#

Dust — Today at 6:14 AM
@Killo. it requires that you probe offsets are correct

@Dust
@Killo. it requires that you probe offsets are correct

Killo. — Today at 6:15 AM
how do i do it ? I am new to everything and it seems so confusing

Dust — Today at 6:15 AM
#define NOZZLE_TO_PROBE_OFFSET { 10, 10, 0 } (edited)
[6:15 AM]
set the X and Y offsets
[6:16 AM]
as per the notes above it

Killo. — Today at 6:16 AM
sorry if i look dumb but it still confuses me so where do i type this
[6:16 AM]
#define NOZZLE_TO_PROBE_OFFSET

Dust — Today at 6:17 AM
marlin is configured by editing two files (edited)
[6:17 AM]
Configuration.h
[6:17 AM]
Configuration_adv.h
[6:17 AM]
this setting is in Configuration.h

west raptor
#

your svo6 isnt modded right its stock

gritty meadow
#

i only have octoprint

#

and i need to do that test i said earlier for autobim

west raptor
gritty meadow
#

nope

#

it is stock

west raptor
#

ight then its a firmware or false reading on the sensor issue

gritty meadow
#

i got told to modify the firmware but idk exactly how and what to modify

west raptor
#

it could be either one but start with checking the sensor before doing big changes

gritty meadow
#

how do i check those, this is my first printer and i dont really know much

west raptor
#

in my case it was one wire being out of place that cause my prints to print 50mm off on the x axis

#

check wire connect to the bed and pull it out of the way

gritty meadow
#

i will send you a video now

gritty meadow