#Artilery Hornet Thermositor cable issue

1 messages · Page 1 of 1 (latest)

fresh schooner
#

So I found out the hot end was installed incorrectly at a 90 degree angle to how it should be. Which was pulling the cable here out. Ive rotated it the way it should be but im still getting the cable not sit properly. And thus still giving me errors. Any ideas? Its not just the cable it seems but also the bit it connects to.

20230709_154758.png
gritty jettyBOT
#
AI Help

It sounds like you might be experiencing an issue with the wiring and connection of your hot end. Here are a few troubleshooting suggestions you can try:

  1. Double-check the alignment: Ensure that you have correctly rotated the hot end to the proper orientation. Make sure it is securely fastened in place.

  2. Inspect the cable and connector: Take a close look at the cable and the connector that connects to the hot end. Look for any signs of damage or misalignment. If you notice any issues, consider replacing the cable and/or connector.

  3. Check for loose connections: Ensure that all the electrical connections between the cable, connector, and control board are securely connected. Sometimes, loose connections can cause errors and connectivity problems.

  4. Test with a different cable: If possible, try using a different cable to connect the hot end. This can help determine if the issue lies with the cable itself.

  5. Contact technical support: If you have gone through these steps an...

WARNING: This response is AI generated and may contain errors.
fresh schooner
#

Not ideal tbh

#

Im curious if I need to replace the board or if theres a way to fix the connection