#Extruder tube filled

1 messages · Page 1 of 1 (latest)

native shore
#

I can't send an image right now, but basically the tube that goes from the cable to the extruder itself in the artillery hornet is clogged.
I cant get it out using the usual tactics of heating it up and then flushing it with filament since the stuck part is above the hot part, so it doesnt heat up or melt. I've tried heating up a screwdriver or small thing and sticking it in there but no result.

restive reefBOT
#
AI Help

If the typical methods of unclogging the tube haven't worked, there are a few alternative approaches you can try:

  1. Cold Pull Method: Heat the hot end to the normal temperature for the filament you are using. Once it's heated, retract the filament completely. Then, while the hot end is still hot, quickly push a new filament into the extruder to force out the clog. This method can sometimes dislodge stubborn clogs.

  2. Manual Disassembly: If the clog is well above the hot end and you can access the tube from above, you may need to disassemble the extruder. Consult your printer's user manual or online resources specific to your printer model for instructions on how to safely disassemble it. From there, you can manually remove the clog using tools like a needle or small wire.

  3. Cleaning Filament: Another option is to use a specialized cleaning filament. These filaments are designed to clean out clogs by scrubbing the inner walls of the tube. Follow the manufacturer's instructions o...

WARNING: This response is AI generated and may contain errors.