mp10 klipper

[ocean thorn]

i have an old monoprice mp10 thats been sitting around for a while un used, i have an sv06 hooked up to a pi 3a+ and want to run the mp10 on that pi aswell. anyone know a cfg i can use for the mp10? or is the mp10 even capable of running klipper ?

[trail orchid]

AI Help

Yes, the Monoprice MP10 is capable of running Klipper firmware. To configure it for your SV06 and Raspberry Pi 3A+, you'll need to modify your printer.cfg file. You can find sample configurations on the Klipper GitHub page, specifically for the Monoprice MP10.

Here are a few steps you can follow to get started:

1. Install Klipper firmware on your Raspberry Pi and set up the necessary connections to your printer.
2. Create a new printer.cfg file or modify the existing one.
3. Find the appropriate configuration file for the MP10 on the Klipper GitHub page. It usually has a name like monoprice-mp10.cfg or similar.
4. Open the configuration file and copy its contents.
5. Paste the copied contents into your printer.cfg file, replacing the existing configuration if necessary.
6. Save and close the file.
7. Restart Klipper or reboot your Raspberry Pi.

Remember to adjust your printer.cfg file with any specific modifications or customizations you might require for your setup.

WARNING: This response is AI generated and may contain errors.

[trail orchid]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.