#Help Setting up hotend and bed in custom dıy printer

1 messages · Page 1 of 1 (latest)

pure cargo
#

I am trying to set up the hot end and bed connections, the thermal sensors and setup the firmware for this. I have a ramps 1.6 board and I decided to use the marlin firmware.

mighty gulchBOT
#
AI Help

Setting up the hot end, bed connections, and thermal sensors with the RAMPS 1.6 board and Marlin firmware involves a few steps. Here's a general guide to help you:

  1. Start by connecting the hot end and heated bed to the appropriate heater outputs on the RAMPS board. Use the "D10" header for the hot end, and the "D8" header for the heated bed.

  2. Connect the temperature sensors for the hot end and bed to the "T0" and "T1" headers on the board, respectively. Make sure to match the sensor polarity correctly.

  3. In the Marlin firmware configuration files, locate the "Configuration.h" file and open it with a text editor. Look for the sections related to the temperature settings.

  4. Uncomment the lines that correspond to the type of temperature sensors you are using (e.g., for a typical thermistor, uncomment the "#define TEMP_SENSOR_X" line and set the appropriate value for "X" based on the sensor type).

  5. Ensure that the correct pins are assigned for the hot end and heated bed tem...

WARNING: This response is AI generated and may contain errors.
pure cargo
#

So ı just connected accordingly, when I make changes in config. I got an error

#

this is the error in arduino ide

mighty gulchBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

pure cargo
#

help

crystal mason
pure cargo
crystal mason
pure cargo
#

I am working on arduino ide

#

I have no experience in coding and this is the easiest way to do according to the internet