#my printer is jammed, I'm new to 3d printing

1 messages · Page 1 of 1 (latest)

covert peak
#

I've already tried replacing both the nozzle and the extruder

timid cloakBOT
#
AI Help

If replacing both the nozzle and the extruder did not solve your issue, there might be other factors to consider. Here are a few troubleshooting steps you can try:

  1. Check the filament: Ensure that the filament is loaded correctly and free of any tangles or obstructions. Also, verify that you are using the correct type of filament for your printer.

  2. Verify proper temperature: Make sure that the printer's hotend is heating up to the correct temperature for your filament. Incorrect temperatures can cause extrusion problems.

  3. Calibrate the extruder: Perform an extruder calibration to ensure that the correct amount of filament is being pushed through the nozzle. This can help address under or over extrusion issues.

  4. Check for clogs: Examine the hotend and nozzle for any signs of filament clogs or debris. Clean them thoroughly if necessary.

  5. Update firmware: Check if there are any firmware updates available for your printer and install them. Firmware updates can sometimes a...

WARNING: This response is AI generated and may contain errors.
covert peak
#

model is cr-m4, and theres a glob of filiment stuck in the feeding bit

timid cloakBOT
covert peak
#

what

hexed ledge
#

nothing, the bot thinks it understands what m4 gcode means but that's not what you were talking about

#

can you post a picture of where it's stuck?

#

don't have any more time right now but that should make it easier for others to help

covert peak
timid cloakBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

covert peak
#

h wh

#

pls anyone help

#

damn

#

buh

covert peak
#

anyone?