#Ender 3 V2 with CR Touch Tramming Wizard Issue

1 messages · Page 1 of 1 (latest)

elfin hound
#

I'm kinda running myself up a wall. Since my last print, I've been having issues with the mriscoc Tramming Wizard on my Ender 3 where it's showing "out of bounds" no matter how I adjust the knobs and it defaults to 0. Any help or insight would be appreciated.

20230626_203131.jpg
lucid epochBOT
#
AI Help

It sounds like you are having an issue with your Ender 3 bed not being level. I recommend using a regular sheet of paper to level your bed manually rather than relying on the firmware's Tramming Wizard. Here are the steps to follow:

  1. Heat your bed and nozzle to printing temperature (usually around 200-220°C and 60-70°C for the bed).
  2. Move the nozzle to each corner of the bed and slide a sheet of paper between the nozzle and the bed.
  3. Adjust the bed height using the leveling knobs until you feel slight resistance on the paper when you try to move it.
  4. Repeat this process for all four corners of the bed until the paper slides evenly across the bed without feeling too loose or too tight.
  5. Finally, check the center of the bed to make sure it is level with the edges by sliding the paper across the middle of the bed.

Once you have manually leveled your bed, the Tramming Wizard should work properly and you should be able to print successfully.

WARNING: This response is AI generated and may contain errors.