#Weird issues with Ender 3 S1 Pro Print Bed

1 messages · Page 1 of 1 (latest)

sullen zephyr
#

I have ran an auto level and fine tunned the corners and tried fine tuning the Z-Offset but it's as if the auto bed level feature is not working. The closer half is too close, and the farther half is too far making it impossible to fine tune and print anything. I have attached the bed mesh below (it is a mesh of the print area, not the entire print bed)

image.png
wise moatBOT
#
AI Help

From the bed mesh, it seems like there is a significant difference in height between the closer and farther halves of the build plate. This could be due to a number of reasons like warped bed or uneven springs, or inaccuracy in the auto level sensor.

To troubleshoot this issue, you can try the following:

  1. Check if the print bed has any noticeable warping. You can use a straight edge tool or a glass surface to check for any curvature.

  2. Try manual bed leveling by loosening the bed screws and adjusting the springs on the corners of the bed. This can help you achieve a more even height across the bed.

  3. Check and calibrate the auto level sensor. Make sure the sensor is clean and free of any debris. Follow the manufacturer's instructions to calibrate the sensor properly.

  4. Try doing a manual mesh bed leveling. This is done by adjusting screws to different points on the bed and measuring the distance between the print head and the bed. It updates the firmware with those measure...

WARNING: This response is AI generated and may contain errors.