severe leveling issues | 3D Printing | Page 1

subtle pike · 2023-06-25T16:32:42.750Z

I’ve tried to level my printer several times and used auto leveling as well as manual, but nothing I do seems to work. It’s either too low or too high and manual adjustments don’t do anything. The auto level seems to be super janky. It’s an sv06

AI Help

If you have tried several levelling methods and still have difficulty getting consistent results, there might be something wrong with your printer's hardware. Here are a few steps that could help you solve this problem:

Check if the bed is warped or has any visible damage. If there are any dents or deformities on the bed surface, it can make levelling much harder.
Make sure the bed is clean and free of debris.
Check if the Z-axis limit switch is working correctly. If it's not, it can cause the printer to have difficulty finding the correct height.
Check the bed sensor or probe. Make sure it's clean and adjusted correctly. Print a bed-leveling test print to see if the bed is even.
Make sure that all screws and joints are tight, and nothing is loose.

If none of these steps work, you might want to reach out to the manufacturer or support for further advice or troubleshooting.

#severe leveling issues