#Kobra Go Bed Leveling

1 messages · Page 1 of 1 (latest)

shadow inlet
#

When leveling using the auto level feature, I’m still getting corners peeling off the bed. I think it’s a leveling issue. I’ve already trammed the Z axis and have a pretty good idea on my z-offset. I’m wondering if I need to adjust the bed itself but don’t know how

late pumiceBOT
#
AI Help

If you are still experiencing corners peeling off the bed even after auto-leveling, there might be a few things you could try:

  1. Ensure that your bed is clean for proper adhesion. You can use isopropyl alcohol or a similar cleaner to wipe down the bed surface before printing.

  2. Adjusting bed temperature: Sometimes, increasing bed temperature can help with the first layer adhesion. You might try to increase the bed temperature by a few degrees see if this resolves the peeling.

  3. Adjust your live Z-offset setting: The live Z-offset setting sets the distance between the nozzle and your bed surface. Adjusting it can make your prints better stick to the bed. You could try to lower the Z-offset by a small increment, then do a test print to see if the issue is resolved.

  4. Check the bed level: Even if you have auto-leveling, it's a good idea to double-check the bed level manually. You could use a piece of printer paper to check the level in all four corners and center of the bed.

I...

WARNING: This response is AI generated and may contain errors.