#Cr Touch

1 messages · Page 1 of 1 (latest)

echo gazelle
#

I did the hardware install on my ender3 for the Cr touch auto leveler kit. Went to the website and downloaded the correct software update for v4.2.2 main board. I flashed the sd card that comes with the ender 3 and then put the software on to it as it says to do in the instructions. But unfortunately when I put the SD card in the software does not update. Any help appreciated

mighty compassBOT
#
AI Help

Here are a few things you can check:

  1. Make sure the firmware file you downloaded matches your specific CR Touch Auto-Leveler kit. Sometimes there could be slight differences in the firmware for different versions of the kit.

  2. Verify that the firmware file is properly named "firmware.bin" and is in the root directory of the SD card. Double-check that the file extension is .bin and not .bin.bin or something similar.

  3. Ensure that the SD card is formatted as FAT32 and is not corrupted. Try formatting it again to see if it helps.

  4. It's also possible that the kit isn't getting power from the motherboard. Check to make sure the pins on the kit are aligned correctly with the motherboard pins, and that the pinout is correct.

If none of these solutions work, you may want to reach out to the manufacturer of the kit for further assistance. Best of luck resolving the issue!

WARNING: This response is AI generated and may contain errors.
echo gazelle
#

i did all that already but thanks bot 😒