#Print Time Estimate

1 messages · Page 1 of 1 (latest)

mossy grove
#

I'm able to reserve time on an Ultimaker 2+
2.85mm PLA filament
I don't think there's a way to get a perfect time estimate, but would four hours be more than enough to print this item?
https://www.thingiverse.com/thing:3405145

PS4 Controller Phone Mount Universal by Chrizlebaer

This is a universal PS4 Dualshock Phone Mount. There are 2 Rubberbands required, one for fixing the mount to the wireless controller and one for the sliding mechanism.
NOTE: This mount works well with Dual Shock Controllers V1.
Dual Shock V2 with light bar could cause problems, but I haven´t tested yet.
UPDATE 07.09.2019
Improved Rubberband Hold...

potent summitBOT
#
AI Help

Based on the size and complexity of the item, it is likely that it would take less than four hours to print on an Ultimaker 2+. However, print time can vary depending on various factors such as printer speed, layer height, and infill percentage. To get a more accurate time estimate, you can slice the model in your preferred slicing software and check the estimated time it provides.

WARNING: This response is AI generated and may contain errors.
fluid wagon
#

Apparently that printer is real fast, 150-300mm/s or so, so yes 4 hours would be suitable

#

As the model needs support too

mossy grove
mossy grove
#

?solved