Unable to center my ender 5 plus

[formal stratus]

hiya, i'm very stuck on why my ender 5 plus isn't centering correctly. I've run several succesful prints and haven't had this issue before. Only recent changes I've done is replace the bowden tube. When I click home / level on the screen, rather than going corner to corner and ending up in the center of my bedplate, it now goes to the absolute right of the center. I haven't changed the firmware, but I reinstalled the stock firmware just in case and it's still the same. How do I change the home/origin to be dead center of the bed again?

[craggy dawn]

AI Help

It sounds like there may be an issue with your printer's firmware configuration for the home position. To fix this issue, you will need to adjust the endstop position in the firmware.

Here are the steps to follow:

1. First, make sure your printer is powered off and unplugged.

2. Next, connect your printer to your computer using a USB cable and open your preferred firmware editing software.

3. Navigate to the configuration.h file in the firmware files.

4. Look for the code that defines where the endstops are and adjust the X and Y positions so that the home position is in the center of your print bed.

5. Once you have made the adjustments, save the changes and upload the new firmware to your printer.

6. Power on your printer, run the auto-home command and test to see if your printer homes to the center of the bed.

If you continue to have issues, there may be an issue with the printer's hardware. In that case, it may be best to contact the manufacturer for further assista...

WARNING: This response is AI generated and may contain errors.