Weird sound while printing | 3D Printing | Page 1

worthy ore Jun 4, 2023, 10:18 PM

#

This happens when the printer starts to print the second round of squares. I tried adjusting the red knob but it doesn’t help.

royal knollBOT Jun 4, 2023, 10:18 PM

#

worthy ore This happens when the printer starts to print the second round of squares. I tri...

#

AI Help

Without additional information, it is difficult to diagnose the exact issue you are experiencing. However, if you are having trouble printing the second round of squares, it could be due to a number of factors such as poor bed adhesion, incorrect leveling, clogged nozzle or a mechanical issue. Here are a few things you can try to resolve the issue:

Check the bed level and adjust it if necessary.
Clean the bed surface to ensure proper adhesion.
Make sure the filament is flowing smoothly through the nozzle.
Check the belt tension and other mechanical components such as the wheels, bearings, and rods to ensure smooth movement of the printer.

If none of these solutions work, please provide a more detailed description of the issue and the printer model you are using for further assistance.

worthy ore Jun 4, 2023, 10:18 PM

#

Im using the anycubic kobra 2

left gazelle Jun 4, 2023, 10:19 PM

#

Z offset too low causing print head to scrape top of print

#

/ e steps for extruder bad so its overextruding

dapper hedge Jun 4, 2023, 10:20 PM

#

sounds nothing like scraping

#

Did you change any firmware settings or flash your own firmware?

#

second round of squares prints faster than the first, so speed is part of the equation

worthy ore Jun 4, 2023, 10:21 PM

#

No i haven’t change anything. I just finished building it and ran the auto leveling and then to print this leveling test

dapper hedge Jun 4, 2023, 10:22 PM

#

Okay. When the printer is powered off, check if the axes can move freely without binding up

#

they should be able to move with some resistance, but mostly with equal and even resistance the whole way through

worthy ore Jun 4, 2023, 10:26 PM

#

They move fine i think?

#

Im not sure if I over tighten the head, with the screws but i dont think that is the problem

dapper hedge Jun 4, 2023, 10:35 PM

#

Move them all the way left to right and front to back to make sure they're not binding

worthy ore Jun 4, 2023, 10:41 PM

#

😭 no they dont. Ahh I hate this…

royal knollBOT Jun 4, 2023, 11:43 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

worthy ore Jun 4, 2023, 11:46 PM

#

.

#Weird sound while printing