can't get filament to feed through ender 3

[gentle robin]

every time i push the filament through, It won't go through the hole and either comes up or circles around that silver metal piece

[raw raft]

AI Help

It sounds like the filament might not be properly inserted into the extruder. Try releasing the tension on the filament and ensuring that it is properly seated in the hot end. Additionally, make sure the hot end is at the proper temperature for the filament you are using. If this issue persists, it might be worth checking if the extruder gear or the bowden tube is damaged or in need of cleaning.

WARNING: This response is AI generated and may contain errors.

[little patio]

Oh noes

Can you push in the white ring on the brass coupler, towards the brass? The tube should be able to come out then

After the tube is out, see if you can feed filament from the output side towards the input again, to make sure the hole is clear

[gentle robin]

how do i do that

doesn't look like it moves

lol

[raw raft]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.